Metal Cap, Metal Chain, Metal Lock Nut

Metal Cap, Plastic Chain, Metal Lock Nut

Vinyl cap and Plastic Lock Nut

Reflect Sampling

• Analyze what's actually in your system

• Delivers more "live" fluid than drain cock, ball/needle valve, dipstick or drain plug methods.

• Sample without shutting down

• Less than 1ml (0.04 fl oz) of deadzone volume to purge

• Avoid the cost of sample retakes and faulty trend data

• Avoid the cost of replacement probes or cross contaminated samples.

Easy to Collect

• Push to open, release to close. Fast, dynamic sampling

• Rotate the spout 360 degrees to the best bottle fill angle.

• Omni-directional. Barb on spout can fit a 3/16" PVC tube (S) to access difficult locations or reduce foaming with higher pressure/velocity samples

• Vacuum sample with suction gun (VAC) and PVC tube (S). Draw the vacuum- push the button.

• One hand operation on low pressure systems using the PVC tube (S) and the bottle vent cap (V).

Easy to Install

• Full spout rotation avoids elbow orientation problems.

• Range of thread, seal options allow the KP to fit directly into most systems.

• Frame mounting bulkhead options using micro hose are available for difficult or unsafe access locations.

Safe and Reliable

• Lock nut behind the pushbutton helps avoid accidental activation and prevents the risk of debris buildup.

• Lock nut can also be used to limit the flow for droplet or film analysis.

• Valve design limits sampling to approximately 750-1000 psi. Operating pressure rated to 6000psi.

• Rugged patented valve. Impulse tested to 1,000,000 cycles at 7800psi.

• Threaded spout & cap gives backup sealing for gases and environmentally sensitive areas.